Subaru Legacy 2004 Service Manual page 3742

GLASS/WINDOWS/MIRRORS
11) Make the same adjustment of two adjusting
bolts of rear sash.
ST 61299AE000 SPACER
(Glass thickness: 5 mm (0.197
in) for front door glass)
A
A
(1) 3.2 — 4.8 mm (0.126 — 0.189 in)
(2) 7 mm (0.276 in)
(3) ST
NOTE:
Do not tilt the sash bracket to inner panel during ad-
justment. Otherwise smooth regulator operation
cannot be achieved.
(1)
(2)
(1) Sash bracket
(2) Rear sash
(3) Adjust a line parallel
(4) Sash
(5) Inner panel
12) Make adjustment of front sash in the same
manner as that of rear sash.
NOTE:
Although front and rear sashes must, as a rule, be
adjusted in the same manner, in some door instal-
lation, the adjustment in a different manner may be
required. However, adjustment of one sash to the
maximum amount and the other to the minimum
amount is not permitted. Such adjustment may re-
sult in application of excessive load to regulator.
13) After adjustments, tighten the nuts.
14) After adjustment of the glass, close the door. If
there is a gap between outer lip of gusset and glass
surface, adjust the gap with adjusting bolt (A) in
Front Door Glass
(1)
(3)
(2)
GW-00336
(4)
(3)
(5)
GW-00270
GW-14
lower fitting part of gusset to prevent generation of
wind noise.
15) During adjustment, loosen the other three
clamping bolts.
16) After adjustment, tighten the bolts and nuts.
(A)
GW-00271