Subaru Legacy 2004 Service Manual page 3325

NOTE:
Do not use this ST for turbo model.
(1) Rack piston inner ring
(2) Outer side oil seal
(3) Rack
8) Apply a coat of grease to the grooves in rack,
sliding surface of sleeve and sealing surface of pis-
ton. Install ST on the end of steering body cylinder.
Then insert the rack into steering body from cylin-
der side.
ST 34199FE050 GUIDE (Turbo and 3.0 R mod-
el)
ST 34199AE000 GUIDE (Except for turbo and
3.0 R model)
CAUTION:
Do not allow grease to block the air vent hole on
rack.
(1) Cylinder side of steering body
(2) Air vent hole
(3) Oil seal
(4) Rack
9) Make the ST2 pass through rack, and then
press-in the rack and ST2 using press.
Press-in the rack until ST1 comes in contact with
ST2 and the edge surface of rack is aligned with
that of ST2.
ST1 34199FE050 GUIDE (Turbo and 3.0 R mod-
el)
34199AE000 GUIDE (Except for turbo and
3.0 R model)
Steering Gearbox [RHD Model]
PS-00078
PS-00079
PS-55
POWER ASSISTED SYSTEM (POWER STEERING)
ST2 34199FE060 INSTALLER (Turbo and 3.0 R
model)
34199AE010 INSTALLER (Except for turbo
and 3.0 R model)
ST1
(1) Outer side oil seal
(2) Rack piston
(3) Inner side oil seal
10) Install a new holder to the cylinder side of steer-
ing body.
Tightening torque:
Turbo and 3.0 R model
#
90 N m (9.18 kgf-m, 66.4 ft-lb)
Except for turbo and 3.0 R model
#
64 N m (6.5 kgf-m, 47.0 ft-lb)
11) Using the ST, caulk the steering body at one
point less than 3mm (0.12 in) from holder.
CAUTION:
Be careful not to deform the holder.
ST2
(1)
(2)
(3)
PS-00431
PS-00498