Subaru Legacy 2004 Service Manual page 3694

WIPER AND WASHER SYSTEMS
10.Rear Wiper Motor
A: REMOVAL
1. SEDAN MODEL
1) Disconnect the ground cable from battery.
2) Remove the rear wiper arm. <Ref. to WW-21,
SEDAN MODEL, REMOVAL, Rear Wiper Arm.>
3) Remove the cap (A) and nut (B) from rear wiper
shaft.
4) Raise the nozzle & hose assembly (C) to discon-
nect the washer tube and remove the nozzle &
hose assembly (C).
5) Disconnect the harness connector of wiper mo-
tor assembly.
6) Remove the bolts to remove wiper motor assem-
bly (A).
2. WAGON MODEL
1) Disconnect the ground cable from battery.
2) Remove the rear wiper arm. <Ref. to WW-21,
WAGON MODEL, REMOVAL, Rear Wiper Arm.>
3) Remove the rear gate lower trim. <Ref. to EI-69,
REMOVAL, Rear Gate Trim.>
4) Disconnect the harness connector of wiper mo-
tor assembly.
Rear Wiper Motor
(A)
(B)
(C)
WW-00180
(A)
WW-00181
WW-22
5) Remove the bolts to remove wiper motor assem-
bly (A).
B: INSTALLATION
1. SEDAN MODEL
1) Install in the reverse order of removal.
2) Align the cutout of reverse side of nozzle & hose
assembly with the cutout of rear wiper shaft for in-
stallation.
2. WAGON MODEL
1) Install in the reverse order of removal.
2) Be sure that the pivot cap with the arrow mark
facing up, as shown in the figure.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion".
<Ref. to WW-5, REAR WIPER (WAGON MOD-
EL), COMPONENT, General Description.>
(A)
WW-00183
WW-00184
WW-00185