Subaru Legacy 2004 Service Manual page 3324

POWER ASSISTED SYSTEM (POWER STEERING)
3) Attach the steering body to ST as shown in the
figure. Apply a coat of grease to needle bearing.
ST1 926200000 STAND
ST2 34199AG000 BOSS D
CAUTION:
Ensure the needle bearing is free from defects.
If it is faulty, replace the steering body with a
new one.
(1) Clamp
4) Using ST-B and ST-C, install the oil seal to ST-
A.
ST 34199FE040 INSTALLER A, B, C (Turbo
and 3.0 R model)
ST 927490000 INSTALLER A, B, C (Except
for turbo and 3.0 R model)
NOTE:
Face the oil seal in the direction as shown in the fig-
ure.
ST B
ST C
(A) Oil seal
Steering Gearbox [RHD Model]
(1)
ST1
ST2
PS-00492
ST A
(A)
PS-00075
5) Insert the ST-A with oil seal assembled from the
gear side of rack. Remove the oil seal from ST-A
near piston, and then remove the ST-A from rack.
(A) Oil seal
(B) Rack
(C) Piston
6) Install the back-up washer from gear side of
rack.
(1) Oil seal
(2) Back-up washer
(3) Rack
7) Install the ST on rack, and equally apply a thin
coat of grease to the rack and ST, then install the oil
seal.
ST 926250000
CAUTION:
Be careful not to scratch the oil seal lips with
the inner ring section of piston.
PS-54
(C)
(B)
ST A
(A)
PS-00076
PS-00077
GUIDE