Subaru Legacy 2004 Service Manual page 2965

C: INSPECTION
Step
1 CHECK G SENSOR.
1) Turn the ignition switch to OFF.
2) Connect the Subaru Select Monitor to data
link connector.
3) Set the Subaru Select Monitor to the {Brake
Control} mode.
4) Set the display in the {Current Data Display
& Save} mode.
5) Read the G sensor output value.
2 CHECK G SENSOR.
1) Remove the console box.
2) Remove the G sensor from vehicle. (Do not
disconnect connector.)
3) Read the Subaru Select Monitor display.
3 CHECK G SENSOR.
Read the Subaru Select Monitor display.
G Sensor
Check
Is the value $1.2 — 1.2 m/s
when the vehicle is in horizon-
tal position?
Is the value 8.1 — 11.2 m/s
when G sensor is inclined for-
%
ward to 90 ?
Is the value $8.1 — $11.2 m/s
when G sensor is inclined
%
backward to 90 ?
ABS-19
Yes
Go to step 2. Repair the har-
2
ness connector
between G sensor
and ABSCM&H/U.
Or replace G sen-
sor.
2 Go to step 3. Repair the har-
ness connector
between G sensor
and ABSCM&H/U.
Or replace G sen-
sor.
2 G sensor is nor- Repair the har-
mal. ness connector
between G sensor
and ABSCM&H/U.
Or replace G sen-
sor.
ABS
No