Subaru Legacy 2004 Service Manual page 3877

B: INSTALLATION
Install in the reverse order of removal.
C: ADJUSTMENT
1. SEDAN MODEL
Loosen the glass lid mounting TORX
and then adjust the height with moving 9.5 mm
(0.374 in) nut (B) on lid side.
Difference in height between glass lid and roof
panel L:
# #
2.0 1.0 mm (0.079
(B)
2. WAGON MODEL
Loosen the glass lid installation nuts, and then ad-
just the height by adding (max: four pieces) or ex-
tracting (min: zero piece) shims (B) (standard: two
pieces) which installed between glass lid (A) and
body.
®
bolts (A),
0.039 in)
(A)
L
SR-00092
Glass Lid
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)
Difference in height between glass lid and roof
panel L:
#
2.0 1.0 mm (0.079
D: FORCED DRIVE
If glass lid dose not operate or is not supplied with
power, move the glass lid using the emergency
handle (wrench)*.
*: Emergency handle (L shape general purpose
hexagon wrench)
Sedan model: bolt width 4 mm (0.16 in)
Wagon model: bolt width 5 mm (0.20 in)
1. SEDAN MODEL
1) Remove the spot map light. <Ref. to LI-34, RE-
MOVAL, Spot Map Light.>
2) Insert the wrench securely until it touches the
motor shaft edge.
3) Turn the wrench, and move the glass lid.
• Turning right, the glass lid open.
• Turning left, the glass lid close.
SR-7
#
0.039 in)
(B)
(B)
L
(A)
SR-00077
SR-00099