Subaru Legacy 2004 Service Manual page 3308

POWER ASSISTED SYSTEM (POWER STEERING)
5) Press the oil seal into place using a press.
ST 34199AG090 INSTALLER & REMOVER
6) Attach the bearing to ST, and then position in
value housing. Using the ST and press, install the
special bearing in valve housing.
ST 34199AG090 INSTALLER & REMOVER
(1) Special bearing
(2) Oil seal
7) Apply vinyl tape to the groove portion of pinion.
Steering Gearbox [LHD Model]
ST
PS-00526
ST
(1)
(2)
PS-00527
PS-38
8) Install the backup ring and oil seal to pinion, and
then remove the vinyl tape.
(1)
(1) Oil seal
(2) Vinyl tape
(3) Backup ring
9) Set the ST to pinion, and install the seal ring.
ST 34199AG020 GUIDE
ST
(1) Seal ring
10) Remove the ST GUIDE, and form the seal ring
properly using ST FORMER.
ST 34199AG070 FORMER
ST
(1) Seal ring
11) Put vinyl tape around the pinion shaft splines to
protect oil seal from damage.
(3)
(2)
PS-00528
(1)
PS-00529
(1)
PS-00530