Subaru Legacy 2004 Service Manual page 3761

18.Rear Quarter Glass
A: REMOVAL
Remove the glass in the same procedure as for
windshield glass. <Ref. to GW-25, REMOVAL,
Windshield Glass.>
(1)
(1) Locating pin
(2) Dam rubber
B: INSTALLATION
1) Install the dam rubber.
(1)
(4)
(3)
(1) Dam rubber
(2) Molding
(3) 10.5 mm (0.413 in) (constant)
(4) Ceramic terminal
Rear Quarter Glass
(2)
(1)
GW-00332
(2)
GW-00333
GW-33
2) Cut out the nozzle head and apply adhesive to
the glass end surface as shown.
(7)
(6)
(2)
(5)
(1) Locating pin
(2) Dam rubber
(3) Adhesive
(4) Molding
(5) 8 — 10 mm (0.31 — 0.39 in)
(6) 15 mm (0.59 in)
(7) 10 mm (0.39 in)
3) Install the glass in the same procedure as for
windshield glass. <Ref. to GW-26, INSTALLA-
TION, Windshield Glass.>
4) After completion of all work, allow the vehicle to
stand for about 24 hours.
NOTE:
• When door is opened/closed after glass is bond-
ed, always lower the door glass and then open/
close it carefully.
• Move the vehicle slowly.
• For minimum drying time and vehicle standing
time before driving after bonding, follow instruc-
tions or instruction manual from the adhesive man-
ufacturer.
5) After curing of adhesive, pour the water on exter-
nal surface of vehicle to check that there are no wa-
ter leaks.
NOTE:
When a vehicle is returned to the user, tell him or
her that the vehicle should not be subjected to
heavy impact for at least three days.
GLASS/WINDOWS/MIRRORS
(2)
(1)
(3)
(3)
(4)
GW-00334