Subaru Legacy 2004 Service Manual page 3808

SEATS
14) Remove the two bolts on each left and right
side, and then remove the reclining motor assem-
bly.
15) Remove the hog rings (A) on the front side of
backrest, and then remove the backrest cover from
backrest.
: (A)
16) Remove the clip (A) and straps (B) on the back
of seat cushion.
(A)
17) Remove the bolt (A) and hook (B) on left and
right side, and then remove the seat cushion frame
from seat rail assembly.
(B)
Front Seat
SE-00388
SE-00372
(B)
SE-00389
(A)
SE-00416
SE-12
18) Remove the hooks (A), and then remove the
seat cushion from seat cushion frame.
(A)
19) Remove the hog rings (A), and then remove the
seat cushion cover from seat cushion pad.
: (A)
20) Remove the hooks and hog rings at the bottom
of headrest, and then remove the headrest cover
from headrest.
D: ASSEMBLY
1. STANDARD SEAT
Assemble in the reverse order of disassembly.
2. POWER SEAT
Assemble in the reverse order of disassembly.
CAUTION:
When the backrest cover is not installed se-
curely, the side airbag module may not be de-
ployed properly, therefore keep strictly to the
following procedure.
• Be careful not to stain or damage the back-
rest cover during assembly.
• Always use new hog rings.
(A)
SE-00391
SE-00339
SE-00342