Subaru Legacy 2004 Service Manual page 3669

34.Door Step Light
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the lens (A), and then remove the door
step light bulb.
(A)
3) Remove the front door trim. <Ref. to EI-48, RE-
MOVAL, Door Trim.>
4) Disconnect the harness connector.
5) Remove the mounting screw from rear side of
trim and remove the door step light.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1) Visually check the bulb for blow out.
2) Check the bulb specification.
<Ref. to LI-2, SPECIFICATION, General Descrip-
tion.>
3) If NG, replace the bulb with a new one.
Door Step Light
LI-00266
LI-00267
LI-39
LIGHTING SYSTEM