Subaru Legacy 2004 Service Manual page 3349

• Turbo model
(1)
(2)
(1) Suction hose
(2) Pressure hose
4) Connect the connector to power steering pump
switch.
5) Install the V-belts to oil pump.
6) Check the tension of V-belt.
<Ref. to ME(H4SO 2.0)-39, INSPECTION, V-belt.>
7) Tighten the belt tension bolt.
Tightening torque:
#
25 N m (2.5 kgf-m, 18.1 ft-lb)
8) Install the pulley belt cover.
9) Install the air intake duct.
<Ref. to IN(H4DOTC)-9, INSTALLATION, Air In-
take Duct.> <Ref. to IN(H4SO 2.0)-9, INSTALLA-
TION, Air Intake Duct.>
10) Connect the battery ground cable to battery.
11) Feed the specified power steering fluid. <Ref.
to PS-84, Power Steering Fluid.>
CAUTION:
Never start the engine before feeding the fluid;
otherwise vane pump might be seized up.
Oil Pump
POWER ASSISTED SYSTEM (POWER STEERING)
PS-00459
PS-79