Subaru Legacy 2004 Service Manual page 3788

Combination Meter Assembly
INSTRUMENTATION/DRIVER INFO
4. Combination Meter Assem-
bly
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Set the tilt steering at the lowest position.
3) Remove the instrument panel under cover and
lower cover of driver's seat side. <Ref. to EI-56,
REMOVAL, Instrument Panel Assembly.>
4) Remove the screws of combination meter (one
for upper side, two for lower side) and pull tilting the
meter toward you.
IDI00101
5) Disconnect the connector in the rear side of
combination meter to remove meter.
CAUTION:
• Be careful not to damage the meter or instru-
ment panel.
• Pay particular attention to avoid damaging
the meter glass.
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
• Make sure the electrical connector is con-
nected securely.
• Make sure that each meter operates normally.
• When the combination meter of model with
immobilizer has been replaced, be sure to per-
form the registration procedure of immobilizer.
IDI-16