Subaru Legacy 2004 Service Manual page 3474

AIRBAG SYSTEM
10.Curtain Airbag Sensor
A: REMOVAL
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the rear seat. <Ref. to SE-14, REMOV-
AL, Rear Seat.>
4) Detach the nuts and disconnect the airbag con-
nector to remove the curtain airbag sensor.
B: INSTALLATION
CAUTION:
Use new nuts (exclusive use for curtain airbag
sensors) during installation.
Install in the reverse order of removal.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to AB-3, CURTAIN AIRBAG SEN-
SOR, COMPONENT, General Description.>
C: INSPECTION
Check for the following, and replace the damaged
parts with new parts.
• Mounting bracket of curtain airbag sensor or con-
nector is damaged.
• Curtain airbag is deployed.
Curtain Airbag Sensor
AB-00727
AB-22