Subaru Legacy 2004 Service Manual page 3684

WIPER AND WASHER SYSTEMS
Step
3 CHECK HARNESS BETWEEN BODY INTE-
GRATED UNIT AND REAR WIPER MOTOR.
1) Turn the ignition switch to OFF.
2) Disconnect the harness connector of body
integrated unit.
3) Disconnect the harness connector of rear
wiper motor.
4) Measure the resistance between the har-
ness connector terminals of body integrated
unit and rear wiper motor.
Connector & terminal
Sedan model
(B280) No. 1 — (R132) No. 2:
(B280) No. 8 — (R132) No. 4:
Wagon model
(B280) No. 1 — (D43) No. 2:
(B280) No. 8 — (D43) No. 4:
4 CHECK OPERATION OF REAR WIPER MO-
TOR.
1) Remove the rear wiper motor.
2) Check the rear wiper motor. <Ref. to WW-
23, INSPECTION, Rear Wiper Motor.>
NOTE:
Rear wiper intermittent time (AT model only)
Select lever position
(AT model only)
Rev
Except for reverse mode
Combination Switch (Wiper)
Is the resistance less than 10
"?
Does the rear wiper motor
rotate normally?
Vehicle speed (km/h (MPH))
—
80 — (50 — )
50 — 80 (31 — 50)
20 — 50 (12 — 31)
0 — 20 (0 — 12)
WW-12
Check
Go to step 4.
End.
Intermittent stopping time (sec.)
Sedan Wagon
Continuous operation
12 3
9 6
6 9
3 12
Yes No
Repair the open
circuit of harness
between body inte-
grated unit and
rear wiper motor.
Replace the rear
wiper motor.