Subaru Legacy 2004 Service Manual page 3471

• Wagon model
10) Remove the airbag guide C from quarter pillar.
• Sedan model
• Wagon model
B: INSTALLATION
CAUTION:
• Refer to "CAUTION" of General Description
before handling the airbag module. <Ref. to AB-
4, CAUTION, General Description.>
• When installing the curtain airbag module, in-
stall a specified part at specified place.
• Be careful not to damage the curtain airbag
module during removal.
• Never open the curtain airbag module before
deploying it. Never reuse the deployed curtain
airbag module.
• Ensure that there are no foreign articles on
airbag module.
Install in the reverse order of removal.
Curtain Airbag Module
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to AB-2, CURTAIN AIRBAG MOD-
ULE, COMPONENT, General Description.>
C: INSPECTION
CAUTION:
Refer to "CAUTION" of General Description be-
fore handling the airbag module. <Ref. to AB-4,
CAUTION, General Description.>
Perform the inspection of following items, and re-
AB-00630
place the damaged parts with new ones. <Ref. to
AB-12, CURTAIN AIRBAG MODULE, INSPEC-
TION, Inspection Locations After a Collision.>
1) With side collision (when curtain airbag is de-
ployed)
• Curtain airbag module assembly
• Roof trim
• Front pillar upper trim
• Center pillar upper trim
• Rear quarter pillar trim
• Airbag guide A, B, C
2) Other replacement parts, which found to be
damaged by visual check
AB-00631
• Assist grip
• Assist grip bracket
• Curtain airbag harness and connector on body
side.
3) With side collision (when curtain airbag is not de-
ployed)
Check the roof trim, pillar trim and airbag module
visually, and then replace them with new ones if
damaged or cracked.
Specially inspect the damage of airbag module
body, mounting bracket, harness connector.
4) Without side collision (dirt and damage of cover)
AB-00632
Replace the corresponding part with a new one.
AB-19
AIRBAG SYSTEM