Subaru Legacy 2004 Service Manual page 3348

POWER ASSISTED SYSTEM (POWER STEERING)
10) Disassemble the oil pump and bracket by in-
serting a flat tip screwdriver as shown in the figure.
B: INSTALLATION
1) Install the oil pump to bracket.
(1) Place the oil pump bracket in a vise. Tighten
the bushing using a 12.7 mm (1/2$) type 14- and
21-mm box wrench until it contact with oil pump
mounting surface.
CAUTION:
When securing the oil pump bracket on a vice,
hold the oil pump bracket with the least possi-
ble force between two wood pieces.
(1) Bushing
(2) Nut
(3) 21 mm
(4) 14 mm
(5) Bolt
(2) Tighten the bolt which holds the oil pump to
bracket.
Tightening torque:
#
15.7 N m (1.6 kgf-m, 11.6 ft-lb)
Oil Pump
Tightening torque:
37.3 N
PS-00129
2) Tighten the bolts which hold the power steering
pump bracket.
3) Interconnect the pressure hose and suction
hose.
Tightening torque:
Eye bolt
CAUTION:
If a hose is twisted at this step, take care the
PS-00135
hose may come into contact with some other
parts.
• Non-turbo model
PS-00128
PS-78
#
m (3.8 kgf-m, 27.5 ft-lb)
#
39 N m (4.0 kgf-m, 28.9 ft-lb)
(2)
(1) Suction hose
(2) Pressure hose
PS-00137
PS-00188
(1)
PS-00460