Subaru Legacy 2004 Service Manual page 3852

Rear Door Latch and Door Lock Actuator Assembly
SECURITY AND LOCKS
10.Rear Door Latch and Door
Lock Actuator Assembly
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the rear door trim. <Ref. to EI-48, RE-
MOVAL, Door Trim.>
3) Remove the wires from rear inner remote. <Ref.
to SL-32, REMOVAL, Rear Inner Remote.>
4) Remove the sealing cover. <Ref. to EB-24, RE-
MOVAL, Rear Sealing Cover.>
5) Remove the rear door glass. <Ref. to GW-22,
REMOVAL, Rear Door Glass.>
6) Remove the rear sash. <Ref. to GW-24, RE-
MOVAL, Rear Regulator and Motor Assembly.>
7) Take out the wire from wire clamp of outer han-
dle.
8) Detach the outer handle bracket. (Model with
double lock)
9) Remove the three screws.
SL-00285
10) Disconnect the connectors, and then remove
the rear door latch & door lock actuator assembly.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Make sure the lock works correctly after installa-
tion.
C: INSPECTION
1) Check the wires for deformation. When it is de-
formed, straighten it because failure operations
may occur. When it is unrepairable, replace the
rear door latch & door lock actuator assembly.
2) Check the lever and wire for smooth operation.
SL-34