Subaru Legacy 2004 Service Manual page 3623

4. OUTER SEAT BELT RH ASSEMBLY AND
LH ASSEMBLY (WAGON MODEL)
1) Remove the luggage floor box. <Ref. to EI-74,
REMOVAL, Luggage Floor Box.>
2) Remove the rear seat cushion and backrest
shoulder. <Ref. to SE-14, SEDAN MODEL, RE-
MOVAL, Rear Seat.>
3) Remove the rear quarter lower trim. <Ref. to EI-
63, WAGON MODEL, REMOVAL, Rear Quarter
Trim.>
4) Remove the bolt to remove outer seat belt re-
tractor.
5) Remove the bolts to remove outer seat belt
guide.
5. SHOULDER SEAT BELT CTR ASSEM-
BLY (WAGON MODEL)
1) Remove the quarter rear pillar trim. <Ref. to EI-
63, WAGON MODEL, REMOVAL, Rear Quarter
Trim.>
2) Remove the seat belt extract opening (A) from
roof trim, and then inset it to the inside of roof trim.
(A)
Rear Seat Belt
3) Remove the clips, and then lower the roof trim
end.
CAUTION:
When removing the roof trim clip, do not pull
the roof trim end backward with excessive
force, otherwise roof trim may be damaged.
4) Remove the bolt to remove seat belt retractor.
SB-00151
6. CENTER SEAT BELT RH ASSEMBLY
AND LH ASSEMBLY (WAGON MODEL)
1) Remove the rear seat cushion. <Ref. to SE-14,
SEDAN MODEL, REMOVAL, Rear Seat.>
2) Remove the bolts, and then detach the center
seat belt assembly.
SB-00158
NOTE:
For the model with rear seat belt warning light, dis-
connect the connector of seat belt warning light.
SB-00159
SB-15
SEAT BELT SYSTEM
SB-00155
SB-00160
SB-00156