Subaru Legacy 2004 Service Manual page 3327

15) Using the ST, install plug.
ST 34199AE090 PLUG WRENCH
Tightening torque:
#
64 N m (6.5 kgf-m, 47.0 ft-lb)
(1) Plug
16) Install the dust cover. Remove the vinyl tape.
(1) Dust cover
17) Temporarily install the tie-rod to the rack, and
then operate it from lock to lock two or three times
to make it fit in. Remove the grease blocking air
vent hole.
CAUTION:
If operating the rack from lock to lock without
installing tie-rod, it may damage the oil seal. Al-
ways install the tie-rods LH and RH.
18) Apply a coat of grease to the sliding surface of
sleeve and seating surface of spring, and then in-
sert the sleeve into spring body.
Steering Gearbox [RHD Model]
PS-00088
(1)
PS-00497
PS-57
POWER ASSISTED SYSTEM (POWER STEERING)
Charge the adjusting screw with grease, and then
insert the spring into adjusting screw and install on
steering body.
(1)
(1) Sleeve
(2) Spring
(3) Adjusting screw
19) Tighten the adjusting screw to specified torque.
Tightening torque:
#
9.8 N m (1.0 kgf-m, 7.2 ft-lb)
20) After tightening the adjusting screw with the
specified tightening torque, loosen it.
Tightening torque:
#
4.9 N m (0.50 kgf-m, 3.6 ft-lb)
21) After tightening the adjusting screw with the
specified tightening torque, loosen 37! it.
Tightening torque:
#
4.9 N m (0.50 kgf-m, 3.6 ft-lb)
22) Remove the tie-rod.
23) Verify that play is within specified value. <Ref.
to PS-61, LIMIT, INSPECTION, Steering Gearbox
[RHD Model].>
24) Loosen the adjusting screw, and then apply liq-
uid gasket to at least 1/3 of the entire perimeter of
adjusting screw thread.
Liquid gasket:
THREE BOND 1141 (Part No. 004403006)
(1) Apply liquid gasket to at least 1/3 of entire
perimeter.
(3)
(2)
PS-00167
PS-00092