Subaru Legacy 2004 Service Manual page 3296

POWER ASSISTED SYSTEM (POWER STEERING)
12) Remove the clamp bolts securing gearbox to
crossmember, and remove the clamp.
(1) Clamp
13) Remove the bolts which secure gearbox brack-
et, and remove the bracket and gearbox.
(1) Bracket
B: INSTALLATION
1) Insert the gearbox into crossmember, being
careful not to damage gearbox boot.
2) Install the gearbox and bracket. Tighten the bolt
temporarily.
(1) Bracket
Steering Gearbox [LHD Model]
(1)
PS-00554
(1)
PS-00555
(1)
PS-00555
PS-26
3) Tighten the gearbox to the crossmember bracket
via clamp with bolt temporarily.
(1) Clamp
4) Tighten the bolts which temporary tightening the
clamp and bracket of gearbox to specified torque.
Tightening torque:
#
60 N m (6.1 kgf-m, 44.1 ft-lb)
5) Connect the pipe D to return hose first, and the
pipe C to pressure hose second.
Tightening torque:
#
15 N m (1.5 kgf-m, 10.8 ft-lb)
(1) Pipe C
(2) Pipe D
(3) Pressure hose
(4) Return hose
6) Install the universal joint. <Ref. to PS-21, IN-
STALLATION, Universal Joint.>
7) Connect the tie-rod end and knuckle arm, and
tighten with castle nut.
(1)
PS-00554
(4)
(3)
(2)
(1)
PS-00538