Subaru Legacy 2004 Service Manual page 3302

POWER ASSISTED SYSTEM (POWER STEERING)
3) Install the seal ring to piston portion of rack.
(1) Using the ST, form the seal ring properly
ST1 34199AG080 FORMER PISTON
ST2 34199AG060 GUIDE G (26) (3.0 R model)
ST2 34199AG050 GUIDE G (24) (Except for 3.0
R model)
ST2
(1) Seal ring
(2) Rack
(2) Using ST-B and ST-C, install the oil seal to
ST-A.
ST 34199FE040 INSTALLER A, B, C (3.0 R
model)
ST 927490000 INSTALLER A, B, C (Except
for 3.0 R model)
NOTE:
Face the oil seal in the direction as shown in the fig-
ure.
ST B
ST C
(A) Oil seal
Steering Gearbox [LHD Model]
(1)
(2)
ST1
PS-00559
ST A
(A)
PS-00075
(3) Insert the ST-A with oil seal assembled from
the gear side of rack. Remove the oil seal from
ST-A near piston, and then remove the ST-A
from rack.
(A) Oil seal
(B) Rack
(C) Piston
4) Install the backup washer from gear side of rack.
(1) Oil seal
(2) Backup washer
(3) Rack
5) Install the ST on rack, and equally apply a thin
coat of grease to the rack and ST, then install the oil
seal.
ST 926250000
CAUTION:
Be careful not to scratch the oil seal lips with
the inner ring section of piston.
PS-32
(C)
(B)
ST A
(A)
PS-00076
PS-00077
GUIDE