Subaru Legacy 2004 Service Manual page 3335

7. Pipe Assembly [LHD Model]
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift-up the vehicle, and then remove the front
crossmember support plate and jack-up plate.
(1)
(1) Front crossmember support plate
(2) Jack-up plate
3) Remove one pipe joint at the center of gearbox,
and connect the vinyl hose to the pipe and the joint.
Discharge the fluid by turning steering wheel fully
clockwise and counterclockwise. Discharge the flu-
id similarly from other pipes.
(1) Pipe A
(2) Pipe B
4) Remove the clamp E from return hose and pres-
sure hose.
(3)
(1) Return hose
(2) Pressure hose
(3) Clamp E
Pipe Assembly [LHD Model]
(1)
(2)
FS-00105
(1)
(2)
PS-00553
(2)
(1)
PS-00537
POWER ASSISTED SYSTEM (POWER STEERING)
5) Disconnect the return hose and pipe D, pressure
hose and pipe C.
(1) Pipe C
(2) Pipe D
(3) Pressure hose
(4) Return hose
6) Remove the
IN(H4DOTC)-9, REMOVAL, Air Intake Duct.>
<Ref. to IN(H4SO 2.0)-9, REMOVAL, Air Intake
Duct.>
7) Disconnect the suction hose and pressure hose
from oil pump.
(2)
(1) Suction hose
(2) Pressure hose
PS-65
(4)
(3)
(2)
PS-00538
air intake duct. <Ref.
(1)
PS-00460
(1)
to