Subaru Legacy 2004 Service Manual page 3267

PARKING BRAKE
B: INSTALLATION
CAUTION:
Be sure the lining surface is free from oil and
grease contamination.
1) Apply brake grease to the following places.
Brake grease:
Brake Grease (Part No. 003602002)
• Six contact surfaces of shoe rim and back plate
packing
• Contact surface of shoe wave and anchor pin
• Contact surface of lever and strut
• Contact surface of shoe wave and adjuster as-
sembly
• Contact surface of shoe wave and strut
• Contact surface of lever and shoe wave
2) Insert the primary side brake shoe into anchor
pin groove.
3) Secure the brake shoe with the shoe hold-down
pin and cup.
4) Install the plate to anchor pin, and then assem-
ble the primary return spring to anchor pin.
(1)
(4)
(5)
(1) Primary return spring
(2) Anchor pin
(3) Plate
(4) Primary shoe
(5) Shoe hold-down pin and shoe hold-down cup
5) Install the parking brake cable to parking brake
lever.
6) Assemble the strut and adjuster, and then se-
cure the secondary side brake shoe with shoe hold-
down pin and cup.
NOTE:
• Install the strut spring of both right and left wheel
facing vehicle front.
Parking Brake Assembly (Rear Disc Brake)
(2)
(3)
PB-00039
• Install the adjuster assembly with screw on left
side.
(1) LH
7) Install the secondary return spring and adjusting
spring.
(1) Lever
(2) Secondary brake shoe
(3) Strut spring
(4) Strut
(5) Return spring
(6) Adjuster
(7) Shoe hold-down cup
(8) Adjusting spring
8) Adjust the parking brake. <Ref. to PB-9, AD-
JUSTMENT, Parking Brake Assembly (Rear Disc
Brake).>
9) Drive the vehicle for parking brake lining "break-
in".
(1) Drive the vehicle at about 35 km/h (22
MPH).
(2) With the parking brake release button
pushed in, pull the parking brake lever gently.
(3) Drive the vehicle for about 200 m (0.12 mile)
in this condition.
(4) Wait 5 to 10 minutes for the parking brake to
cool down.
Repeat once more from step (1).
(5) After breaking-in, re-adjust the parking
brakes.
PB-8
PB-00016
(1)
(2)
(4)
(3)
(5)
(7)
(6)
(8)
PB-00017