Subaru Legacy 2004 Service Manual page 3775

Combination Meter System
INSTRUMENTATION/DRIVER INFO
2. Combination Meter System
A: WIRING DIAGRAM
1. COMBINATION METER
<Ref. to WI-130, WIRING DIAGRAM, Combination
Meter.>
B: INSPECTION
1. SELF-DIAGNOSIS
The self-diagnosis (checking of each meter, warn-
ing light, indicator, illumination, LCD, buzzer
sound) of combination meter can be performed in
the following procedure.
1) Connect the diagnostic connector (A) near the
fuse & relay box.
(A)
IDI00133
2) Turn the ignition switch to ON.
3) While meter indicator needle deflecting, press
the odo/trip meter knob twice.
NOTE:
When odo/trip meter knob is pressed only once,
display mode is shifted to DTC display mode. <Ref.
to IDI-12, DTC DISPLAY MODE, INSPECTION,
Combination Meter System.>
When the self-diagnosis function is operated, the
checking of warning light, indicator, and LCD dis-
play is performed, hereafter, every pressing the
odo/trip meter knob, the operation check is per-
formed in the order of meter, illumination and buzz-
er. <Ref. to IDI-4, LIST OF SELF-DIAGNOSIS
MODE OPERATION, INSPECTION, Combination
Meter System.> To cancel the self-diagnosis
mode, set the ignition switch to OFF or disconnect
the diagnosis connector.
NOTE:
When the engine starts during diagnosis, the self-
diagnosis mode is not cancelled, however, once
the vehicle starts driving, the self-diagnosis mode
is cancelled automatically for safety.
IDI-3