Subaru Legacy 2004 Service Manual page 3475

Roll Connector
AIRBAG SYSTEM
11.Roll Connector
A: REMOVAL
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the driver's airbag module. <Ref. to AB-
14, REMOVAL, Driver's Airbag Module.>
4) Remove the steering wheel. <Ref. to PS-20, RE-
MOVAL, Steering Wheel.>
5) Remove the steering column cover.
6) Remove the screws, and then remove the roll
connector.
AB-00760
B: INSTALLATION
1) Install in the reverse order of removal.
2) Before installing steering wheel, be sure to ad-
just the direction of roll connector with steering.
<Ref. to AB-23, ADJUSTMENT, Roll Connector.>
C: INSPECTION
Check for the following, and replace the damaged
parts with new parts.
• Combination switch and roll connector are
cracked or deformed.
D: ADJUSTMENT
1) Check that front wheels are positioned in straight
ahead direction.
2) Turn the roll connector pins (A) clockwise until it
stops.
3) Turn the roll connector pins (A) approx. 3.25
turns until "L" marks are aligned.
(A)
AB-00594
AB-23