Subaru Legacy 2004 Service Manual page 2984

3. CLEAR MEMORY MODE
1) On the «Main Menu» display screen, select the
{2. Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display
screen, select the {Brake Control} and press the
[YES] key.
3) Press the [YES] key after the {ABS} is displayed.
4) On the «Brake Control Diagnosis» display
screen, select the {Clear Memory} and press the
[YES] key.
Display
Clear memory? Function of clearing DTC.
5) When "Done" and "Turn ignition switch OFF" are
shown on the display screen, turn the Subaru Se-
lect Monitor and ignition switch to OFF.
NOTE:
For details concerning operation procedure, refer
to the "SUBARU SELECT MONITOR OPERATION
MANUAL".
4. ABS SEQUENCE CONTROL
Display Contents to be monitored
Operate the valve and
ABS
pump motor continuously
sequence
to perform the ABS
control
sequence control.
5. FREEZE FRAME DATA
NOTE:
• Data stored at the time of trouble occurrence is
shown on display.
• Each time trouble occurs, the latest information
is stored in the freeze frame data in memory.
• Freeze frame data will be memorized up to three.
• If a Freeze Frame Data is not properly stored in
memory (due to a drop in ABS control module pow-
er supply, etc.), the DTC which is suffixed with a
question mark "?" appears on the Subaru Select
Monitor display. This shows it may be an unreliable
reading.
Display
Wheel speed detected by the Front ABS
FR Wheel wheel speed sensor RH is displayed in
km/h or MPH.
Wheel speed detected by the Front ABS
FL Wheel wheel speed sensor LH is displayed in
km/h or MPH.
Wheel speed detected by the Rear ABS
RR Wheel wheel speed sensor RH is displayed in
km/h or MPH.
Wheel speed detected by the Rear ABS
RL Wheel wheel speed sensor LH is displayed in
km/h or MPH.
Subaru Select Monitor
Contents to be monitored
Index No.
<Ref. to ABS-
10, ABS
Sequence Con-
trol.>
Contents to be monitored
ABS(diag)-17
Display Contents to be monitored
IG power supply Voltage supplied (V) to ABSCM&H/U is
voltage displayed.
Vehicle acceleration detected by analog
G Sensor
G sensor is displayed.
Motor relay mon-
Motor relay condition is displayed.
itor
BLS Signal Brake ON/OFF is displayed.
Vehicle speed calculated by ABS control
Vehicle speed
module is displayed.
ABS Control
ABS control condition is displayed.
Flag
Power Supply Whether abnormal voltage occurred or
Failure not is displayed during malfunction.
ABS (DIAGNOSTICS)