Subaru Legacy 2004 Service Manual page 3253

14.Brake Pedal
A: REMOVAL
1. LHD MT MODEL
1) Remove the steering shaft.
2) Disconnect the connectors (stop light switch)
from pedal bracket.
3) Remove the clevis pin which secures lever to
push rod.
4) Remove the nuts which secure clutch master
cylinder.
5) Remove the bolts and nuts which secure pedal
bracket.
2. LHD AT MODEL
1) Remove the steering shaft.
2) Disconnect the connectors (stop light switch)
from pedal bracket.
3) Remove the clevis pin which secures lever to
push rod.
Brake Pedal
4) Remove the bolts and nuts which secure pedal
bracket.
BR-00128
3. RHD MODEL
Refer to LHD AT model. <Ref. to BR-43, LHD AT
MODEL, REMOVAL, Brake Pedal.>
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
Always use new clevis pins.
2) Inspect the brake pedal after installation. <Ref.
to BR-43, INSPECTION, Brake Pedal.>
C: INSPECTION
1) Move the brake pedal pads in the lateral direc-
tion with a force of approx. 10 N (1 kgf, 2 lb) to en-
sure pedal deflection is in specified range.
BR-43
(1)
(3)
(1) Clevis pin
(2) Snap pin
(3) Operating rod
BRAKE
(2)
BR-00351