Subaru Legacy 2004 Service Manual page 3774

INSTRUMENTATION/DRIVER INFO
1. General Description
A: SPECIFICATION
Combination meter
B: CAUTION
• Be careful not to damage the meters and instrument panel.
• Be careful not to damage the meter glass.
• Make sure the electrical connector is connected securely.
• After installation, make sure that each meter operates normally.
• Use gloves to avoid damage and getting fingerprints on the glass surface and meter surfaces.
• Do not apply an excessive force on the printed circuit.
• Do not drop or otherwise apply impact.
• When the combination meter of model with immobilizer has been replaced, be sure to perform the regis-
tration procedure of immobilizer.
C: PREPARATION TOOL
1. GENERAL TOOL
TOOL NAME
Circuit tester
General Description
Speedometer
Tachometer
Water temperature gauge
Fuel gauge
Malfunction indicator light
Oil pressure warning light
ABS warning light
Airbag warning light
Seat belt warning light
Door open warning light
Brake fluid and parking brake warning light
Low fuel warning light
Charge warning light
ATF temperature warning light
AWD warning light
Vehicle dynamics control (VDC) warning light
Vehicle dynamics control (VDC) indicator light
Turn signal indicator light
HI-beam indicator light
Immobilizer indicator light
Cruise indicator light
Cruise set indicator light
Front fog light indicator light
Rear fog light indicator light
AWD LO indicator light
SPORT indicator light
AT select lever position indicator light
Light illumination indicator light
Meter illumination light
LCD back light
Odo/Trip indicator
SPORT shift indicator
Used for measuring resistance and voltage.
IDI-2
Stepping motor type
LED
LCD
REMARKS