Subaru Legacy 2004 Service Manual page 3337

Tightening torque:
#
39 N m (4.0 kgf-m, 28.9 ft-lb)
(2)
(1) Suction hose
(2) Pressure hose
5) Temporarily connect the pressure hose and pipe
C, the return hose and D. Place the clamp E in the
position shown in the figure, and tighten the bolt
temporarily.
(3)
(4)
(1) Return hose
(2) Pressure hose
(3) Approx. 18 mm (0.71 in)
(4) Clamp E
(5) Pipe C
(6) Pipe D
Pipe Assembly [LHD Model]
(1)
PS-00460
(1)
(2)
(6)
(5)
PS-00539
POWER ASSISTED SYSTEM (POWER STEERING)
NOTE:
Ensure that the letter "8" on each clamp are diago-
nally opposite each other as shown in the figure.
(2)
(1) Clamp E
(2) Pressure hose
(3) Return hose
6) Tighten the clamp E.
Tightening torque:
#
7.4 N m (0.75 kgf-m, 5.4 ft-lb)
7) Tighten the pressure hose and pipe C, the return
hose and pipe D.
Tightening torque:
#
15 N m (1.5 kgf-m, 10.8 ft-lb)
8) Connect the pipe A and B to the four pipe joints
of gearbox.
Tightening torque:
#
13 N m (1.3 kgf-m, 9.4 ft-lb)
(1) Pipe A
(2) Pipe B
9) Install the front crossmember support plate and
jack-up plate.
10) Lower the vehicle.
11) Tighten the bolts which hold the hose bracket.
PS-67
(1)
(3)
PS-00540
(1)
(2)
PS-00553