Subaru Legacy 2004 Service Manual page 3467

5. Passenger's Airbag Module
A: REMOVAL
CAUTION:
Refer to "CAUTION" of "General Description"
before handling the airbag module. <Ref. to AB-
4, CAUTION, General Description.>
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the instrument panel. <Ref. to EI-56,
INSTRUMENT PANEL (EXCLUDING STEERING
SUPPORT BEAM), REMOVAL, Instrument Panel
Assembly.>
4) Remove the pawl and remove the passenger's
airbag module.
5) Refer to "CAUTION" for handling of a removed
airbag module. <Ref. to AB-4, CAUTION, General
Description.>
B: INSTALLATION
CAUTION:
Refer to "CAUTION" of General Description be-
fore handling the airbag module. <Ref. to AB-4,
CAUTION, General Description.>
Install in the reverse order of removal.
CAUTION:
Do not allow harness and connectors to inter-
fere or get tangled up with other parts.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to AB-2, PASSENGER'S AIRBAG
MODULE, COMPONENT, General Descrip-
tion.>
Passenger's Airbag Module
C: INSPECTION
CAUTION:
Refer to "CAUTION" of General Description be-
fore handling the airbag module. <Ref. to AB-4,
CAUTION, General Description.>
Check for the following, and replace damaged
parts with new parts.
• Airbag module, harness, connector, and mount-
ing bracket are damaged. <Ref. to AB-12, PAS-
SENGER'S AIRBAG MODULE, INSPECTION,
Inspection Locations After a Collision.>
EI-00615
AB-15
AIRBAG SYSTEM