Subaru Legacy 2004 Service Manual page 3620

SEAT BELT SYSTEM
5. Front Seat Belt
A: REMOVAL
1. OUTER SEAT BELT ASSEMBLY
1) Turn the ignition switch to OFF, disconnect the
battery ground cable from battery, and wait for
more than 20 seconds before starting work.
2) Fold the backrest all the way forward, and then
move the front seat all the way forward.
3) Remove the center pillar lower trim. <Ref. to EI-
60, REMOVAL, Lower Inner Trim.>
4) Remove the center pillar upper trim. <Ref. to EI-
62, REMOVAL, Upper Inner Trim.>
5) Remove the bolt, and remove the center pillar in-
ner protector lower.
6) Remove the bolt, and then remove the shoulder
anchor.
7) Remove the bolt, and then remove the adjust-
able anchor assembly.
Front Seat Belt
8) Disconnect the pretensioner connector (A), and
remove the bolt, and then remove the seat belt re-
tractor.
NOTE:
Disconnect the tension reducer connector (B) for
the seat belt retractor with tension reducer function.
CAUTION:
• Do not drop or apply any impact to the pre-
tensioner.
• Since the pretensioner and bracket are inte-
grated as a unit, do not disassemble them.
2. INNER SEAT BELT ASSEMBLY
1) Turn the ignition switch to OFF, disconnect the
battery ground cable from battery, and wait for
SB-00144
more than 20 seconds before starting work.
2) Remove the console box. <Ref. to EI-53, RE-
MOVAL, Console Box.>
3) Disconnect the seat belt warning light connector
under the seat.
4) Remove the harness clips from seat rail.
5) Remove the TORX
inner seat belt assembly.
SB-00152
SB-00153
SB-12
(B)
(A)
®
bolt, and then remove the
SB-00154
SE-00332