Subaru Legacy 2004 Service Manual page 3319

NOTE:
When adjusting toe-in, hold the boot as shown to
prevent it from being rotated or twisted. If twisted,
straighten it.
C: DISASSEMBLY
1) Disconnect the pipes A and B from steering body
and control valve housing.
(2)
(1) Pipe A
(2) Pipe B
2) Secure the gearbox removed from vehicle in a
vice using ST.
ST1 926200000 STAND
ST2 34199AG000 BOSS D
CAUTION:
Secure the gearbox assembly in a vice using
the ST as shown. Do not secure the gearbox
without this ST.
(1) Clamp
Steering Gearbox [RHD Model]
PS-00051
(1)
PS-00496
(1)
ST1
ST2
PS-00492
POWER ASSISTED SYSTEM (POWER STEERING)
3) Remove the tie-rod end and lock nut from gear-
box.
4) Remove the clip from outside boot using pliers,
and then move the boot to tie-rod end side.
(1) Clip
5) Using a flat tip screwdriver, remove the band
from boot.
NOTE:
Replace the boot if there is damage, cracks or de-
terioration.
(1)
(1) Band
6) Using the ST, loosen the lock nut.
ST 926230000
(1)
(1) Lock nuts
PS-49
PS-00053
PS-00493
SPANNER
ST
PS-00494