Subaru Legacy 2004 Service Manual page 3660

LIGHTING SYSTEM
25.Rear Fog Light Bulb
A: REMOVAL
1. SEDAN MODEL
1) Remove the bulb inspection cover of trunk side
trim.
2) Turn the socket and remove the bulb.
2. WAGON MODEL
1) Remove the rear fog light assembly. <Ref. to LI-
23, REMOVAL, Rear Fog Light.>
2) Remove the mounting screws, and then remove
the rear fog light assembly.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1. SEDAN MODEL
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATION, General Description.>
3) If NG, replace the bulb with a new one.
2. WAGON MODEL
1) Install the rear fog light assembly to check that it
illuminate normally.
2) If it does not illuminate, replace the rear fog light
assembly with a new one.
NOTE:
Since LED (Light Emitting Diode) is used for the
rear fog light, replace the rear fog light assembly
when the LED is powered off.
Rear Fog Light Bulb
LI-00302
LI-00292
LI-30