Subaru Legacy 2004 Service Manual page 3882

SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)
5. Sunroof Motor
A: REMOVAL
CAUTION:
• When removing the clip, use great care not to
damage the roof trim.
• Never rotate the sunroof motor after remov-
ing it.
1. SEDAN MODEL
1) Completely close the glass lid.
2) Disconnect the ground cable from battery.
3) Remove the roof trim. <Ref. to EI-67, SEDAN
MODEL, REMOVAL, Roof Trim.>
4) Disconnect the harness connector, and then re-
move the motor assembly mounting screw.
CAUTION:
When removing the motor assembly, secure
the cable wires to prevent moves.
2. WAGON MODEL
1) Fully close the glass lid (front) and glass lid
(rear).
2) Disconnect the ground cable from battery.
3) Remove the luggage room light. <Ref. to LI-36,
REMOVAL, Luggage Room Light.>
4) Remove the roof trim. <Ref. to EI-67, WAGON
MODEL, REMOVAL, Roof Trim.>
5) Pass the seat belt tongue (A) located on center
of rear seat through the hole, and then pull it out to
the opposite side of trim.
(B)
6) Remove the clips, and then drop the rear end of
roof trim.
Sunroof Motor
SR-00088
(A)
SR-00036
7) Disconnect the harness connector (A), and then
remove the motor assembly mounting bolt (B) and
nuts (C).
(A)
B: INSTALLATION
CAUTION:
When installing the motor assembly, be careful
not to move the sunroof cable.
SR-12
(C)
(B)
(C)
SR-00089