Subaru Legacy 2004 Service Manual page 3298

POWER ASSISTED SYSTEM (POWER STEERING)
4) Remove the small clip from the boot using pliers,
and then move the boot to tie-rod end side.
(1) Clip
5) Using a flat-tip screwdriver, remove the band
from boot.
NOTE:
Replace the boot it there is damage, cracks or de-
terioration.
(1) Band
6) Using the ST, loosen the lock nut.
ST 926230000 SPANNER
(1)
(1) Lock nut
Steering Gearbox [LHD Model]
(1)
PS-00508
(1)
PS-00509
ST
PS-00494
7) Tighten the adjusting screw until it no longer
tightens.
(1) Adjusting screw
8) Hold the rack with a wrench [22 mm width across
flats], and then remove the tie-rod using a wrench
[32 mm width across flats] or adjustable wrench.
9) Loosen the adjusting screw, and then remove
the spring and sleeve.
10) Remove the two bolts securing valve assem-
bly.
PS-28
(1)
PS-00495
PS-00511
PS-00116