Subaru Legacy 2004 Service Manual page 3696

WIPER AND WASHER SYSTEMS
11.Rear Washer
A: REMOVAL
1. SEDAN MODEL
1) Remove the rear wiper arm. <Ref. to WW-21,
SEDAN MODEL, REMOVAL, Rear Wiper Arm.>
2) Remove the cap (A) and nut (B) from rear wiper
shaft.
3) Raise the nozzle & hose assembly (C) to discon-
nect the washer hose, and remove the nozzle &
hose assembly (C).
2. WAGON MODEL
1) Detach the roof spoiler. <Ref. to EI-40, REMOV-
AL, Roof Spoiler.>
2) Remove the washer hose from washer nozzle.
3) Push the pawl of nozzle from the reverse side of
roof spoiler with a flat tip screwdriver or equivalent,
and remove the washer nozzle.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Adjust the washer nozzle. <Ref. to WW-24, AD-
JUSTMENT, Rear Washer.>
C: INSPECTION
• Make sure the nozzle and hose are not clogged.
• Make sure the hose is not bent.
D: ADJUSTMENT
1) Turn the wiper switch to OFF position.
2) While the vehicle is at standstill, adjust the wash-
er injection position as shown in the figure.
Rear Washer
(A)
(B)
(C)
WW-00180
WW-00214
WW-24
NOTE:
Injection position of rear washer nozzle is adjust-
able only for sedan model.
• Sedan model
(1) Nozzle
(A) 310 mm (12.20 in)
(B) 5.5%
• Wagon model
(1) Nozzle
(A) 70 mm (2.76 in)
(B) 70%
B B
A
(1)
WW-00189
(1)
A
B
WW-00054