Subaru Legacy 2004 Service Manual page 3812

SEATS
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to SE-4, REAR SEAT (SEDAN
MODEL), COMPONENT, General Descrip-
tion.>
2. WAGON MODEL
Install in the reverse order of removal.
NOTE:
• After installing the backrest, make sure that each
seat belt operates normally.
• Make sure that they are secured on each hook of
vehicle side.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to SE-5, REAR SEAT (WAGON
MODEL), COMPONENT, General Descrip-
tion.>
C: DISASSEMBLY
1. SEDAN MODEL
1) Remove the rear seat. <Ref. to SE-14, SEDAN
MODEL, REMOVAL, Rear Seat.>
2) Remove the headrest.
3) Remove the nuts, and then detach the trunk
through assembly.
4) Remove the hog rings (A) on the rear side of
backrest.
: (A)
Rear Seat
5) Remove the hog rings (A) on the front side of
backrest.
6) Remove both sides of armrest hinge covers, and
loosen the screws to remove armrest.
7) Remove the hook, and then detach the center
through cover.
SE-00347
8) Remove the hook, and then remove the armrest
cover.
SE-00352
SE-16
: (A)
SE-00353
SE-00354
SE-00355
SE-00356