Combination Base Switch Assembly - Subaru Legacy 2004 Service Manual

Hide thumbs Also See for Legacy 2004:

Table of Contents

11.Combination Base Switch

1) Remove the driver's airbag module. <Ref. to AB-

14, REMOVAL, Driver's Airbag Module.>

2) Remove the steering wheel. <Ref. to PS-20, RE-

MOVAL, Steering Wheel.>

3) Remove the screws and remove the steering

column lower cover.

4) Remove the combination switch. <Ref. to LI-10,

REMOVAL, Combination Switch (Light).> <Ref. to

WW-8, REMOVAL, Combination Switch (Wiper).>

5) Remove the four screws and remove the roll

6) Remove the three screws.

7) Disconnect the connector and remove the com-

bination base switch assembly.

B: INSTALLATION

1) Install in the reverse order of removal.

2) Before installing steering wheel, be sure the di-

rection of roll connector is adjusted with steering.

<Ref. to AB-23, ADJUSTMENT, Roll Connector.>

C: INSPECTION

1. COMBINATION BASE SWITCH ASSEM-

Inspect the combination base switch assembly and

roll connector for crack or deformation. If any dam-

age is found, replace with a new one.

Combination Base Switch Assembly

2. PARKING SWITCH

Measure the resistance between parking switch

Switch position

Terminal No.

LIGHTING SYSTEM

Less than 1 !

Table of Contents