Subaru Legacy 2004 Service Manual page 3470

AIRBAG SYSTEM
7. Curtain Airbag Module
A: REMOVAL
CAUTION:
Refer to "CAUTION" of General Description be-
fore handling the airbag module. <Ref. to AB-4,
CAUTION, General Description.>
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the rear quarter trim. (Sedan model)
<Ref. to EI-63, SEDAN MODEL (MODEL WITH
CURTAIN AIRBAG), REMOVAL, Rear Quarter
Trim.>
4) Remove the quarter rear pillar trim. (Wagon
model) <Ref. to EI-63, WAGON MODEL, REMOV-
AL, Rear Quarter Trim.>
5) Disconnect the curtain airbag module connector.
• Sedan model
• Wagon model
6) Remove the roof trim. <Ref. to EI-67, REMOV-
AL, Roof Trim.>
7) Remove the bolts (A) and clips (B), and then re-
move the curtain airbag module.
CAUTION:
• Be careful not to damage the curtain airbag
module during removal.
• Never open the curtain airbag module before
deploying it. Never reuse the opened curtain
airbag module.
Curtain Airbag Module
• Sedan model
• Wagon model
NOTE:
Remove the rear center seat belt retractor on the
RH side before servicing.
8) Remove the airbag guide A from front pillar.
AB-00623
9) Remove the airbag guide B from center pillar.
• Sedan model
AB-00624
AB-18
(B)
(A)
(A)
(A)
(B)
(A)
(A)
(B)
(A)
(A)
(A)
(A)
(A)
(B)
(A)
(A)
(A)
AB-00625
(A)
(A)
(A)
AB-00626
AB-00628
AB-00629