Subaru Legacy 2004 Service Manual page 3741

7) After adjusting the clearance between center pil-
lar, up and down the glass several times to check
glass contact to stopper when glass is fully closed.
Adjust it to contact the front and rear stopper simul-
taneously.
(1) Narrow
(2) Wide
(3) When the stopper of door sash (rear) contacts
first
(4) When the stopper of door sash (front) contacts
first
(5) Raise B channel
(6) Lower B channel
8) For adjustment of the upper and lower ends of
center pillar, loosen the adjusting nut (A) of B-chan-
nel (B).
Front Door Glass
(1)
(3)
(2)
(5)
(2)
(4)
(1)
(6)
GW-00324
(B)
(A)
GW-00269
9) For glass stroke adjustment, install the ST to
glass, close the door, and raise the glass with reg-
ulator until positional relationship between glass
and weather strip becomes as shown. And secure
the glass so that the upper stopper correctly touch-
es the glass holder.
ST 61299AE000 SPACER
(1) 3.2 — 4.8 mm (0.126 — 0.189 in)
(2) 7 mm (0.276 in)
(3) ST
For preventing wind noise, adjust the glass at the
position where tip of gusset is raised up a little.
(A) 0 — 1.5 mm (0 — 0.059 in)
10) After stabilizer adjustment, carry out the glass
cohesion adjustment. First, visually ensure the po-
sitional relationship between retainer & molding
and glass of the roof side, and then begin with rear
sash adjustment. Install the ST to glass and adjust
two adjusting bolts alternately step by step to ob-
tain dimensions shown below (cross-section A).
NOTE:
If two nuts are loosened at the same time, the sash
moves back and forth. Therefore, when one nut is
adjusted, secure the other.
GW-13
GLASS/WINDOWS/MIRRORS
(Glass thickness: 5 mm (0.197
in) for front door glass)
(1)
A
A
(3)
(2)
GW-00336
(A)
GW-00325