Subaru Legacy 2004 Service Manual page 3306

POWER ASSISTED SYSTEM (POWER STEERING)
CAUTION:
Right side boot has groove for identification.
Be sure to install the boots after identifying left
and right boots.
(1)
(1) Right side boot
(2) Groove for identification
NOTE:
Make sure that the boot is installed without unusual
inflation or deflation.
Steering Gearbox [LHD Model]
(2)
PS-00524
PS-00194
PS-36
33) Install a new boot band. Using band clamp pli-
ers, caulk the boot band until caulking part clear-
ance is 2 mm (0.079 in) or less.
(A)
(A) Boot band
(B) 2 mm (0.079 in) or less
34) Fix the boot end with clip (small).
(1) Clip
35) After installing, check the boot end is posi-
tioned into groove on tie-rod.
36) If the tie-rod end has been removed, screw in
the lock nut and tie-rod end to screwed portion of
tie-rod, and then tighten the lock nut temporarily in
a position as shown in the figure.
(B)
PS-00499
PS-00053