Subaru Legacy 2004 Service Manual page 3754

GLASS/WINDOWS/MIRRORS
B: INSTALLATION
1) Clean the external circumference of windshield
glass with alcohol or white gasoline.
2) Remove the adhesive layer on the body using
cutter knife to obtain smooth face of 2 mm (0.08 in)
thick.
CAUTION:
Be careful not to damage the body and paint
surface.
(1)
(1) Adhesive
(2) 2 mm (0.08 in)
(3) Dam rubber
(4) Glass
3) Clean the body with alcohol or white gasoline to
eliminate cutting power, dust and dirt completely
from body.
4) Align the locating pin of glass side with the hole
of body side, and place the glass on the body.
Windshield Glass
(3)
(2)
(4)
GW-00071
5) Adjust the glass position to make uniform clear-
ance between body and glass in four corners.
(4)
(1) Locating pin
(2) Dam rubber
(3) 9 mm (0.354 in)
(4) 11 mm (0.433 in)
6) Remove the glass temporarily from body.
7) Install the dam rubber.
8) Fit molding mark (B) to notch (A) of glass side
and install the molding to entire perimeter of glass.
GW-26
(4)
(1)
(2)
(3)
GW-00315
(A)
(B)
GW-00316