Subaru Legacy 2004 Service Manual page 3864

Hide thumbs Also See for Legacy 2004:

Table of Contents

SECURITY AND LOCKS

20.Body Integrated Unit

• Prepare the security ID plate.

• Prepare all registered immobilizer keys for the

model with immobilizer.

• Make a registration of immobilizer for the model

with immobilizer. For detailed operation procedure,

refer to "IMMOBILIZER REGISTRATION MANU-

• If replacing the body integrated unit, check the

current setting and note it. <Ref. to LAN(diag)-17,

CONFIRMATION OF CURRENT SETTING, OP-

ERATION, Subaru Select Monitor.>

1) Disconnect the ground cable from battery.

2) Remove the instrument panel lower panel on

driver's side. <Ref. to EI-56, REMOVAL, Instru-

ment Panel Assembly.>

3) Disconnect the connector of body integrated

Be careful to keep water and other foreign ma-

terials away from body integrated unit.

4) Remove the body integrated unit from the body

integrated unit mounting bracket using flat tip

screwdriver.

Be careful not to damage the unit when remov-

ing it forcibly from the bracket.

5) Remove the clutch pedal stopper arm. (MT mod-

el) <Ref. to CL-26, REMOVAL, Clutch Pedal.>

6) Remove two body integrated unit bracket mount-

ing bolts, and remove the bracket.

B: INSTALLATION

Install in the reverse order of removal.

Make sure it comforms to the current setting condi-

tion after installation. <Ref. to LAN(diag)-17, CON-

OPERATION, Subaru Select Monitor.>

Body Integrated Unit

Chapters

Table of Contents