Subaru Legacy 2004 Service Manual page 3232

BRAKE
5) Install the pad on support.
NOTE:
Install the pad indicator in proper direction.
(1)
(2)
(6)
(3)
(6)
(5)
(4)
(1) LH # IN
(2) LH # OUT
(3) RH # IN
(4) RH # OUT
(5) Pad indicator
(6) Pad return spring
CAUTION:
• Correctly install the pad return spring to sup-
porting surface of pad clip as shown in the fig-
ure.
• When the pad return spring is deformed or
damaged, replace the brake pad with new one.
(1) Pad return spring
(2) Supporting surface of pad clip
6) Install the caliper body on support.
Front Disc Brake Assembly
(6)
(5)
(6)
BR-00342
(1)
(2)
BR-00343
BR-22
7) Using new brake hose gaskets, connect the
brake hose.
Tightening torque:
"
18 N m (1.8 kgf-m, 13.0 ft-lb)
8) Bleed air from brake system.
C: DISASSEMBLY
1. 15-INCH TYPE
1) Clean mud and foreign particles from the caliper
body assembly and the support.
CAUTION:
Be careful not to allow foreign particles to enter
inlet (at brake hose connector).
2) Place a wooden block in caliper body as shown
in the figure to prevent piston from jumping out and
avoid being damaged.
3) Gradually supply compressed air via installation
hole of brake hose to force the piston out.
(1) Place a 30 mm (1.18 in) wide wood block here.
4) Remove the piston boot.
5) Remove the piston seal from caliper body cylin-
der.
(1)
BR-00026
BR-00240