Subaru Legacy 2004 Service Manual page 3341

8. Pipe Assembly [RHD Model]
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift-up the vehicle, and then remove the front
crossmember support plate and jack-up plate.
• Large type
(1) Front crossmember support plate
• Small type
(1)
(1) Front crossmember support plate
(2) Jack-up plate
3) Remove one pipe joint at the center of gearbox,
and connect the vinyl hose to the pipe and the joint.
Discharge the fluid by turning steering wheel fully
clockwise and counterclockwise. Discharge the flu-
id similarly from other pipes.
(1) Pipe A
(2) Pipe B
Pipe Assembly [RHD Model]
(1)
PS-00445
(1)
(2)
FS-00105
(1)
(2)
PS-00446
POWER ASSISTED SYSTEM (POWER STEERING)
4) Remove the clamp E from the return hose and
pressure hose.
(1) Return hose
(2) Pressure hose
(3) Clamp E
5) Disconnect the return hose and pressure hose
from gearbox.
(1) Return hose
(2) Pressure hose
PS-71
(2)
(3)
PS-00542
(2)
(1)
PS-00543
(1)