Clutch Switch - Subaru IMPREZA 2002 Service Manual

CLUTCH SWITCH
I
CLUTCH SYSTEM
11 .Clutch Switch
A: REMOVAL
1 ) Disconnect the ground terminal from battery.
2) Disconnect the connector from clutch switch.
3) Remove the clutch switch.
B: INSTALLATION
1) Move the clevis pin of the push rod right and left
and hold where it moves smoothly, then measure
stroke of clutch pedal.
Specified clutch pedal full stroke:A
130
-
135 mm (5.12
-
5.31 in)
Tightening torque:
T: 8 N-m (0.8 kgf-m, 5.8 ft-lb)
04M 1
19OC
2) If the clutch pedal stroke is out of specification,
adjust the stroke. <Ref. to CL-27, ADJUSTMENT,
Clutch Pedal.>
3) Connect the clutch switch connector.
C: INSPECTION
1) If the clutch switch does not operate properly (or
if it does not stop at the specified position), replace
with a new one.
Specified position: L
P'.5/omm (0.079+0.059/0 in)
I L
G4M0327
2) Check the clutch switch continuity. If continuity is
not as specified, replace the switch.
(1) Disconnect the clutch switch connector.
(2) Measure the resistance between 1 and 2 of
clutch switch terminal.
When clutch pedal depressed:
Terminals/Specified resistance
1
-
ZLess than 1 0
Termina WSpecified resistance
1
-
ZMore than lMSZ
When clutch pedal not depressed:
Clutch switch (Starter interlock)
Clutch switch (With cruise control)
TR0541
(3) If not as specified, replace the clutch switch.
C L-30