Protocol-Based Vlan Configuration Commands; Display Protocol-Vlan Interface - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – VLAN Commands
Caution:
The port command is only applicable to access ports. To add trunk ports and hybrid
ports to a VLAN, you can use the port trunk permit vlan and port hybrid vlan
commands in Ethernet port view. For related command information, refer to the Port
Basic Configuration Command section of the 3Com Switch 7750 Command Reference
Guide.
Related command: display vlan.
Example
# Add Ethernet1/0/1 through Ethernet1/0/3 to VLAN 2.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] vlan 2
[3Com-vlan2] port Ethernet1/0/1 to Ethernet1/0/3

1.3 Protocol-Based VLAN Configuration Commands

1.3.1 display protocol-vlan interface

Syntax
display protocol-vlan interface { { interface-type interface-number [ to interface-type
interface-number ] } | all }
View
Any view
Parameter
{ interface-type interface-number [ to interface-type interface-number ] }: Specifies the
port number of the protocol to be displayed. If you do not use the to keyword, only one
port is specified. If you use the to keyword, multiple contiguous ports are specified. The
interface-type argument refers to the port type and the interface-number argument
refers to the port number.
all: Displays the protocol-related information about all ports.
Description
Use the display protocol-vlan interface command to display the protocol-based
VLAN information, including VLAN ID, protocol index and protocol type.
Related command: display interface.
Chapter 1 VLAN Configuration Commands
1-12