Display Vlan - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – VLAN Commands

1.1.4 display vlan

Syntax
display vlan [ vlan-id [ to vlan-id ] | all | static | dynamic ]
View
Any view
Parameter
vlan-id: Specifies the VLAN ID, ranging from 1 to 4094.
to: Specifies multiple contiguous VLAN IDs.
all: Specifies to display the information about all the VLANs.
static: Specifies to display the VLANs created statically.
dynamic: Specifies to display the VLANs created dynamically.
Description
Use the display vlan command to display the information about specified VLANs or all
VLANs.
If the vlan-id argument or the all keyword is specified, the information about the
specified VLANs or the all VLANs is displayed, including VLAN ID, VLAN type (dynamic
or static), routing function status (If enabled, the primary IP address and mask are
displayed), VLAN description and VLAN name, VLAN broadcast storm suppression
ratio, and VLAN member ports.
If no argument or keyword is specified, this command displays the list of all the existing
VLANs. If the dynamic or static keyword is specified, this command displays the list of
the VLANs that are created dynamically or statically.
Related command: vlan.
Example
# Display the information about VLAN 2.
<3Com> display vlan 2
VLAN ID: 2
VLAN Type: static
Route Interface: not configured
Description: VLAN 0002
Name: VLAN 0002
Broadcast MAX-ratio: 100
Tagged Ports: none
Chapter 1 VLAN Configuration Commands
1-4