Vlan To - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – VLAN Commands
View
System view
Parameter
vlan-id: ID of the VLAN that you want to enter. Its value ranges from 1 to 4094.
to: Specifies the range of VLANs to be removed.
all: Specifies to remove all VLANs.
Description
Use the vlan command to enter a VLAN view. If the VLAN identified by the vlan-id
argument does not exist, this command creates the VLAN and then enters the VLAN
view.
Use the undo vlan command to remove a VLAN.
Caution:
The protocol reserved VLAN, Voice VLAN, the system default VLAN (VLAN 1) and
remote-probe VLAN cannot be removed by the undo vlan command.
When you use the undo vlan command to remove a VLAN which is the default
VLAN of an access port, a trunk port or a hybrid port on the device, the port will use
VLAN 1 as the default VLAN after the undo vlan command is executed.
Related command: display vlan
Example
# Enter VLAN 1 view.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] vlan 1
[3Com-vlan1]

1.1.9 vlan to

Syntax
vlan vlan-id1 to vlan-id2
undo vlan vlan-id1 to vlan-id2
Chapter 1 VLAN Configuration Commands
1-8