3Com 7750 Series Command Reference Manual page 61

3Com Switch 7750 Series
Command Reference Guide – VLAN Commands
View
System view
Parameter
vlan-id: ID of the initial VLAN to be created, in the range of 1 to 4,094.
to: Specifies the range of VLANs.
vlan-id2: ID of the terminal VLAN to be created, in the range of 1 to 4,094, no smaller
than the vlan-id1 argument.
Description
Use the vlan to command to create multiple VLANs in batch.
Use the undo vlan to command to remove multiple VLANs in batch.
Caution:
VLAN 1 is the default VLAN, which need not be created and cannot be removed.
Protocol-reserved VLANs, Voice VLANs, default VLAN (namely, VLAN1), share
VLANs and remote-mirroring-enabled test VLANs cannot be directly removed by
using the undo vlan to command.
Example
# Create VLAN 4 to VLAN 100 in batch.
<3Com> system-view
Enter system view, return to user view with Ctrl+Z.
[3Com] vlan 4 to 100
This operation may take a few minutes.
Please wait...
Done.
[3Com]
# Display all the VLANs in the switch after multiple VLANs are created in batch.
[3Com] display vlan
Now, the following VLAN exist(s
1(default), 4-100
--- 98 VLAN(s) found
Chapter 1 VLAN Configuration Commands
---
1-9